The assembly process of the water meter mechanism covers several key steps, mainly involving the tight integration of the case and the plug board, the precise placement of the gear shaft and the stabilization measures.
Precise docking of the case and the plug board: First, ensure that the interface design between the case and the plug board is both firm and easy to operate. The special mounting hole at the bottom of the case is designed for barrier-free plugging of the gear shaft, and its edges are rounded to facilitate the smooth rotation and insertion of the gear shaft. An opening is cleverly opened at the top of the case to match the toothed design of the edge of the plug board, and the connection is ensured to be accurate and stable by interlocking.
Installation and locking of the gear shaft: The gear shaft is precisely inserted from the bottom of the case, and its upper end carries a pointer to indicate the water flow measurement. In order to prevent the gear shaft from shifting inside the water meter mechanism, a limit device is set at the end of the gear shaft and the top of the inner wall of the case to form a double insurance. At the same time, an innovative limit structure is introduced between the plug board and the housing, which consists of a limit groove and an elastic block. This design not only enhances the fixing effect of the plug board, but also improves the structural strength and stability of the entire water meter mechanism.
Preparation and compliance with specifications before installing the water meter mechanism: Before formal installation, be sure to thoroughly clean the inside of the pipe and remove all impurities that may hinder the normal operation of the water meter, such as sand, gravel, hemp, etc., to avoid water meter failure. In addition, the installation process of the water meter mechanism must strictly comply with industry specifications and standards to ensure the accuracy and reliability of water meter measurement.
